Skip to content


One-stop Electronics Manufacturing Services

PCB Design Board

When you have good electronics projects but don’t know how to start, KINGFORD can provide good service anything you want. Such as PCB Design Board.

PCB is the foundation of all electronic products. The PCB design is very important in our service. Firstly, please allow me to share what is the KINGFORD Layout service. Secondly, what we can do for you:

1. Create a new PCB engineering drawing

2. Built a new schematic and PCB file

3. Built BOM List

4. Design PCB circuit diagram

● Design PCBs dimensions and format
● Put down the correspondent component on the file
● Routine then it connects all the component
● Adjust all the component and wiring when finish routing
● Save the document and output file

5. Make a report, include schematic’s netlist

6. Import schematic’s netlist to the PCB document

7. Design PCB (include layout and Copper pour etc)

● Planning PCB
● Set up the parameter of PCB
● Import schematic’s netlist and B.O.M
● Component distribution
● Auto-routing
● Adjust manually
● Save the document and output file

8. Double-check via DRC

9. Make a final report – pcb design board

● Please do a layout and wiring base on a schematic.
● Please check the original document before layout, it can save something that can reuse (such as DDR and master chip), then break up the rest of the file and delete unnecessary line and hole.
● Set up all the component’s location. The Master chip system set on the basis of every receiver port, pay attention to the direction and position.
● Arrange all the function module by a single from the schematic, don’t take it together, then, arrangement outside PCB.
● You can fine adjustment all the function module during the complete arrangement, make it achieve a reasonable connection between modules, finally, PCB layout uniform, beautiful and reasonable.
● Please kindly consider the power supply when layout, It is necessary to plan which power sources are divided by planes and which are to be routed. The relevant power sources should be put together as much as possible, and a clear current flow should be made.